Angelo Po 12WFAAA Bedien- Und Installationshandbuch Seite 26

Important
Make a daily check that the safety devices are prop-
erly installed and in good working order. Make a daily
check that the safety devices are properly installed
and in good working order.
Caution - warning
The floor, near the appliance, could be slippery.
Important
The necessary connections (water, electricity and
gas) must be set up exclusively by suitably special-
ised staff , in accordance with local requirements.
Important
Do not dump pollutant material in the environment.
Dispose of it in compliance with the relevant laws.
Important
Before carrying out any servicing procedure, acti-
vate all the safety devices provided and decide
whether staff at work and those in the vicinity should
be informed.
Important
Before starting any cleaning operation, always turn
off the gas supply tap, cut off the electricity supply
using the master switch and allow the appliance to
cool.
Caution - warning
When using detergents, rubber gloves, protective mask
and safety goggles must be worn in accordance with
the relevant safety regulations.
Caution - warning
Never use products containing substances harmful or
hazardous for health (solvents, petroleum spirits, etc.).
Caution - warning
Before doing any work, cut off the mains electricity
supply.
Important
Before it is put into service, the system must be test-
ed to check the operating conditions of every single
component and identify any malfunctions. In this
stage, it is important to check that all health and safe-
ty requirements have been complied with in full.
Important
Before making any type of adjustment, activate all
the safety devices provided and decide whether staff
at work and those in the vicinity should be informed.
Important
Before carrying out any replacement procedure, ac-
tivate all the safety devices provided and decide
whether staff at work and those in the vicinity should
be informed.
Caution - warning
Do not obstruct the flue to avoid the temperature of
the combustion components and products from in-
creasing excessively over the admissible limits.