Vortice VORT HR 300 NETI Betriebsanleitung Seite 55

Pre-alarm: "Check filters"
After the pre-set amount of time has passed, "Alarm!" appears on the "HOME" page and the following note appears on the
"Alarms" page: "Check or clean filters". To replace filters, follow the instructions contained in the paragraph on "Maintenance
and Cleaning".
Press the [] key and the following will appear:
Alarm: "Filters to be replace"
After the preset period of time, "Alarm!" appears in "HOME" and on the "Alarms" page the note: "Replace reset".
To replace filters, follow the instructions contained in the paragraph on "Maintenance and Cleaning".
Press the [] key and the following will appear:
Note: When filter timer is reset the counter is also reset.
Alarm: No Frost - Wait one hour
The device is provided with temperature probes which measure air temperature.
If temperatures are too low, "No Frost", "Alarm!" "Block!" appear on the "HOME" page and the following note appears on the
"Alarm" page: "Wait 1 hour". Press the [] key and the following will appear:
Alarm: "Ext Probe fault"
Equipment is provided with a temperature probe which measures the temperature of air incoming from the outside. The
probe fault causes the message "Alarm!" to appear on the "HOME" page and the following note appears on the "Alarms"
page: "Ext Probe call service". Press the []key and the following will appear:
Call Customer service to request assistance from technical personnel.
YES
[ ▲ ]
9 9
[ ] [
[ ▲ ]
NO
[ ▲ ]
9 9
[
[ ]
[ ▲ ]
NO
[ ▲ ]
9 9
[ ] [
[ ▲ ]
[ ▲ ]
9 9
9 9
[ ]
[ ]
ENGLISH
9 9
]
9 9
]
9 9
] ]
55