Vortice VORT HR 300 NETI Betriebsanleitung Seite 36

ENGLISH
- The appliance must be installed in such a way as to ensure that under normal operating conditions, no one can
come into contact with any moving parts or live electrical components.
- The appliance internal parts must be cleaned only by a skilled professional.
- Regularly inspect the appliance for visible defects. If the appliance is defective in any way, do not use it, and
contact a VORTICE authorised Technical Support Centre without delay.
i
OBLIGATION
- Follow the safety instructions to prevent any harm to the user.
- Las instrucciones para el mantenimiento deben cumplirse para evitar daños y/o desgaste excesivo del aparato.
d
PROHIBITION
- Do not use this appliance for functions other than those described in this booklet.
- Do not leave packaging within reach of children or individuals with disabilities.
- Do not operate the appliance where inflammable vapours or substances are present (alcohol, insecticides, petrol,
etc.)
- Do not make modifications of any kind to this appliance
- Do not expose the appliance to the weather (rain, sun, etc.).
- Do not stand objects on the appliance.
- The appliance cannot be used to pilot the operation of water heaters, stoves, etc.; neither must it drain into the
hot water ducts of such appliances.
- Never cover the device exhaust and supply to ensure optimal air passage.
a
ATTENTION
- Certain fundamental rules must be observed when using any electrical appliance:
– never touch the appliance with wet or damp hands.
– never touch the appliance while barefoot.
- The flow of extracted air must be clean (i.e. free of grease, soot, chemical and corrosive agents and explosive or
flammable mixtures).
- Keep the air intake and outlet ports of the appliance free of obstructions, to ensure optimum air flow.
- Maximum operating temperature: 45°C.
p
OBLIGATION
- In the case of:
– dismantle the appliance, using the proper tools.
– heat exchanger removal.
– motor module removal.
the appliance must first be switched off and disconnected from the electrical power supply.
- Switch off the system main switch when:
– a malfunction is detected.
– you decide to perform external cleaning maintenance.
– you decide not to use the device for short or long periods.
5 Structure and equipment
The main components of the device are:
• An external body composed of a polypropylene foam shell and a front cover panel
• A polystyrene counter cross flow heat exchanger, whose particular morphology guarantees a very high heat exchange
efficiency; H models are equipped with an enthalpy exchanger, which is also able to transfer the humidity present in the
air.
• Two brushless, low consumption motors with two pre-set operating speeds
• Management electronics which oversee the power supply and command and control of the device:
• Temperature sensors (bypass and defrosting)
• User panel, located on the front panel of the device
• Remote panel (optional)
• Two filters: G4 and M5
Note well: For Passive House compliant systems it will be necessary to replace the M5 filter housed in the external air
intake duct with F7 class filters.
36