Vortice VORT HR 300 NETI Betriebsanleitung Seite 53

• HEAT FORC: (only where combined with the Pre-Heater accessory) upon electric heater (Pre-Heater) installation, a
"correct operation test" can be performed on the heater itself, forcing its activation. If "Heat Forc" is Activated, the device
will activate the electric heater for 15 seconds; after which, the "Heat Forc" function will Deactivate.
NO FROST
UN-BALAN. Å
HEATER
HEAT FORC
NO FROST
UN-BALAN.
HEATER
Å
HEAT FORC
NO FROST
UN-BALAN.
HEATER
HEAT FORC Å
"FAN SPEED" page
Select "FAN SPEED" from the "INSTALL" menu to access the speed adjustment menu.
Motor speed can be adjusted depending on the system flow rates, selecting:
FAN1 = (A) Clean air supply in room
• FAN 1 MIN = Minimum speed
• FAN 1 MAX = Maximum speed
[ ▲ ]
9 9 9 9
[ ] ]
[ ]
[ ▲ ]
NO
[ ▲ ]
9 9
9 9
[ ] ]
[ ]
[ ▲ ]
NO
YES
[ ▲ ]
9 9
9 9
[ ] [ ] ]
NO
[ ▲ ]
[ ▲ ]
FAN2 = (D) Stale air supply toward outside
• FAN 2 MIN = Minimum speed
• FAN 2 MAX = Maximum speed
Activate/deactivate "Un-balan." function
Use the [▲] and [▼] keys to select "HOLIDAY":
Press the[]key:
• To activate choose [YES].
• To deactivate choose [NO].
Activate/deactivate "Heater" function.
Use the [▲] and [▼] keys to select "HOLIDAY":
Press the[]key:
• To activate choose [YES].
• To deactivate choose [NO].
Activate/deactivate "Heat Forc" function.
Use the [▲] and [▼] keys to select "HOLIDAY":
Press the[]key:
• To activate choose [YES].
• To deactivate choose [NO].
ENGLISH
[ ▲ ]
53