Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation and operating manual
–
Press the DOWN button and pull the rope upwards out of
the hoist.
DANGER!
Danger of death due to electric shock!
–
Disconnect the hoist from the power supply by pulling out
the plug.
–
Pull out the power plug.
–
See Fig. 5: Whilst lowering wind up the ropes (1) in the
correct position or onto a reel to ensure that there are no
loops (2), which would make the ropes unusable..
–
Loosen the anchorage of the hoist.
–
Dismantle the deflection rollers and load bearing points.
13
Shutting down
13.1 Work breaks
The workplace must be secured as follows during work breaks:
–
Put the load lifting equipment on the ground or cordon off
the area beneath the suspended load.
–
Disconnect the power supply and secure the hoist against
unauthorized use.
13.2 Temporary shutdown
If the hoist is not required for several days or weeks but should
remain mounted in the same position and location, the hoist must
be secured as follows:
–
Put the load lifting equipment on the ground or cordon off
the area beneath the suspended load.
–
Secure the load lifting equipment against oscillating move-
ments (e.g. tie to building).
–
Pull up the rope without load to a position out of the reach of
people.
–
Disconnect the power supply and secure the hoist against
unauthorized use.
13.3 Permanently decommissioning
–
Dismantle the product and accessories, see '12 Dismantling'
on page 17.
–
Clean the outside of the product and then store it away.
EN-18
14
Transport and storage
14.1 Transport
General transporting instructions
Ensure that no damage occurs during the transporting.
Always use suitable transport equipment and get a second per-
son to help you with heavy components.
Hoist
–
On-site, the hoist can be transported using the carrying
handle, see Fig. 1. If necessary transport with the help of a
second person.
–
Heavy hoists can be transported using suitable transport
equipment on the eye bolts or ring nuts.
–
Utilize the transport box when transporting with a vehicle.
Secure the hoist or the transport box with lashing straps.
Ropes
–
Transport the ropes on the reels whenever possible.
–
Rolled-up ropes without reels should be lifted and trans-
ported using a lifting strap.
–
Minimize the load resulting from the dead weight as much
as possible.
14.2 Storage
General storage conditions:
Dry location (maximum of 75% relative humidity)
Dust-free
Even ambient temperature
Wire rope storage conditions:
Lightly greased
Avoid contact with chemicals (e.g. battery acid)
Store without any mechanical crushing, pressure or tensile
stress
Protect the ropes against direct sunlight, chemicals, soiling
and mechanical damage.
G919.6 - 07/2012
Werbung
