Herunterladen Inhalt Inhalt Diese Seite drucken

Pressure Control Assembly / Disassembly; Storage; Maintenance And Spare Parts - Profi Cook PC-SKT 1101 Bedienungsanleitung, Garantie

Schnellkochtopf-set
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4

Pressure control assembly / disassembly

It might be necessary to remove the pressure control for maintaining or cleaning. In order to do so, you
need a SW 13 screw-wrench and on top of that require some technical know-how and craftsmanship. Ask
for help if necessary.
Disassembly
1. Turn the lid over and loosen the cap nut including the O-ring located underneath.
2. Lift the pressure control up. Careful with the seal!
3. Separate the button from the valve by turning and pressing.
Assembly
4. Once you have cleaned or replaced the parts, you can assemble the button and the valve again by
turning and pressing.
NOTE:
The button and valve only match in one direction.
5. Place the bigger seal in the lid from above with the side of the groove facing down.
6. Reinstall the pressure control. Use the profile in the lid.
7. First apply the O-ring to the thread of the pressure control.
8. Then attach the cap nut.
9. Gently tighten the cap nut using the screw-wrench.
10. The pressure control must turn with little resistance.
11. If not, readjust the cap nut.
Handle the sealing ring carefully!
• Store the sealing ring inside the lid.
IMPORTANT: Place the lid upside down on the cooker. That allows for the sealing ring to remain in
good condition.
• Store the cooker / sealing ring in a dark place that is protected from sunlight or rather UV radiation.
Maintain the function and safety of your pressure cooker
Worn parts must be replaced regularly. Use original spare parts only.
• Replace the sealing ring and other silicone parts after no more than 2 years.
Is there any other part that is damaged, deformed, cracked or in poor condition?
We offer different spare parts.
The spare parts listed below can be ordered from your dealer.
Description
PC-SKT 1101 Lid, complete
PC-SKT1101 Pressure control
PC-SKT 1101 Valve with silicone ring, washer, cap nut

Storage

Maintenance and spare parts

Spare part number
8910710
8910711
8910712
89

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis