Setting The Adjustment Screw; General - Fronius Robacta KD Drive Bedienungsanleitung

Setting the adjustment screw

General

For a precise reading or for making an adjustment to the contact pressure on the
feed rollers, the adjusting screw (24) acts as a pressure display. The pressure is
displayed by means of divisions - a wide, bright ring and a narrow red ring. The
more divisions are visible on the adjusting screw, the greater the contact pressu-
re.
Setting the ad- IMPORTANT! It is only possible to set the adjustment screw when the welding
justment screw wire is threaded in.
Al-, AlSi and AlMg-wires:
-
CuSi-, Fe- and CrNi-wires:
-
max. contact pressure:
-
1
2
3
44
Al-, AlSi and AlMg-wires:
1 / division 1
2
1 1
/ to 1 / divisions showing
2 2
2 to 3 1 / divisions showing
2
3 1 / divisions showing
2
Close the swivel lever (16)
Allow the clamp (23) to engage
Set the adjusting screw (24) as shown in the illustration
1 / divisions 2 divisions
2
CuSi-, Fe- and CrNi-wires:
3 1 / divisions
2
T
1
T
3
T ... Division 1
1
T ... Division 2
2
T ... Division 3
3
(24)
(23)
(16)
T
2