Fronius Robacta KD Drive Bedienungsanleitung Seite 39

(16)
Swivel lever closed
Unscrew the outlet nozzle from the feed pipe
Attach the cold-wire feed cable to the mains and set the mains switch to "I"
14
WARNING!
Danger from emerging welding wire.
This can result in serious injury.
▶
Keep face and body well away from torch
Press wire advance button (1) on the Robacta KD Drive, until the welding wire
15
emerges from the torch.
If the wire jams in the Robacta KD-Drive roller:
- Stop the threading process immediately (Release the wire advance but-
ton (1))
- Open the tension lever (16)
WARNING!
Danger from rotating feed rollers.
This can result in serious injury.
▶
Do not touch the feed rollers.
- Introduce the welding wire using wire advance (1) and wire reverse (2) in-
to the burner-side inlet/outlet nozzle
- Press wire advance (1) until the welding wire emerges from the torch
- End Feeding welding wire procedure
-
Close tension lever (16)
End „Feeding weld wire" process by releasing the the wire advance button (1)
16
Check that the swivel lever (16) on
12
the Robacta KD Drive is closed.
Unscrew the outlet nozzle (17)
13
from the feed pipe
(17)
39