IFM Electronic CR2032 Handbuch Seite 42

C M M
OMPACT ODULE ETAL
Index S-Idx Designation
2000 0C Configuration
channel 4, pin 2
0D Configuration
channel 5, pin 2
0E Configuration
channel 6, pin 2
0F Configuration
channel 7, pin 2
10 Configuration
channel 8, pin 2
2001 0
20F0 0 Setting of the
20F1
20F2 0 Setting of the
20F3 Baud rate
The entries 20F0/20F1 and 20F2/20F3 must always contain identical values.
The new entries are valid after a reset (switching the module off/on).
Values outside the permissible ranges will be rejected.
*)
Observe hex-code switch position!
Entries under 20F0/20F1 and 20F2/20F3 are only valid if the hex-code switches for baud rate (S1)
and/or node ID (S2, S3) are in the position "F".
(for position and coding of the hex-code switches see page 33)
42
PAGE
CR2032
Type
u8, rw
output
u8, rw
input
u8, rw
output
u8, rw
input
u8, rw
output
PWM u8, rw
Frequency
u8, rw
*)
Node ID
u8, rw
*)
Default Description
0x02 0 = OFF
2 = binary output
0x03 0 = OFF
3 = voltage 0...10,000 mV
6 = ratiometric 0...1000 ‰
7 = current 0...20,000 µA
9 = voltage 0...32,000 mV
A = binary input
with analogue evaluation
B = binary input
with analogue evaluation
(with diagnosis)
0x02 0 = OFF
2 = binary output
0x03 0 = OFF
3 = voltage 0...10,000 mV
6 = ratiometric 0...1000 ‰
7 = current 0...20,000 µA
9 = voltage 0...32,000 mV
A = binary input
with analogue evaluation
B = binary input
with analogue evaluation
(with diagnosis)
0x02 0 = OFF
2 = binary output
0x64 Setting in Hz (20...250 Hz)
(100 Hz) If an invalid value is entered, the
previous value remains valid.
0x20 The node ID used to access the module
(= 0d32) in the CANopen network.
0x04 Baud rate of the CAN network
0 = 1000 kBaud
1 = 800 kBaud
2 = 500 kBaud
3 = 250 kBaud
4 = 125 kBaud (default)
5 = 100 kBaud
6 = 50 kBaud
7 = 20 kBaud