Safety Instructions - IFM Electronic CR2032 Handbuch

Safety instructions

This description is part of the unit. It contains texts and drawings
concerning the correct handling of the module and must be read
before installation or use.
Observe the information of the description. Non-observance of the notes,
operation which is not in accordance with use as prescribed below, wrong
installation or handling can result in serious harm concerning the safety of
persons and plant.
The instructions are for authorised persons according to the EMC and low
voltage guidelines. The unit must be installed and commissioned by a skilled
electrician (programmer or service technician). The device may only be
installed, connected and commissioned by qualified personnel.
Disconnect the device externally before doing any work on it. If necessary,
also disconnect separately supplied output load circuits.
If the unit is not supplied by the mobile on-board system (12/24 V battery
operation) it must be ensured that the external voltage is generated and sup-
plied according to the criteria for safety extra-low voltage (SELV) as this is sup-
plied without further measures to the connected controller, the sensors, and
the actuators.
The wiring of all signals in connection with the SELV circuit of the unit must
also comply with the SELV criteria (safe extra-low voltage, safe electrical sepa-
ration from other electric circuits).
If the supplied SELV voltage has an external connection to ground (SELV
becomes PELV) the responsibility lies with the user and the respective national
regulations for installation must be complied with. All statements in these
operating instructions refer to the unit the SELV voltage of which is not
grounded.
The terminals may only be supplied with the signals indicated in the technical
data or on the unit label and only the approved accessories of ifm electronic
gmbh may be connected.
The unit can be operated within a wide temperature range according to the
technical specification indicated below. Due to the additional self-heating the
housing walls can have high perceptible temperatures when touched in hot
environments.
In case of malfunctions or uncertainties please contact the manufacturer.
Tampering with the unit can lead to considerable risks for the safety of per-
sons and plant. It is not permitted and leads to the exclusion of any liability
and warranty claims.
C M M
OMPACT ODULE ETAL
CR2032
27
PAGE