orbit controls OCM642 Betriebsanleitung Seite 52

Orbit Controls AG
:SYSTem:COMMunicate:GPIB:ADDRess
Syntax:
:SYSTem:COMMunicate:GPIB:ADDRess <DNPD>
:SYSTem:COMMunicate:GPIB:ADDRess?
Description:
This commands allows set communication GPIB address
Parameters:
<DNPD>
Remarks:
Overlapped command
Value is not affected by reset
Example:
SYST:COMM:GPIB:ADDR 2
SYST:COMM:GPIB:ADDR? Response: 2
:SYSTem:COMMunicate:LAN:ADDRess
Syntax:
:SYSTem:COMMunicate:LAN:ADDRess <CPD>
:SYSTem:COMMunicate:LAN:ADDRess?
Description:
This command allows to change IP address if DHCP is switched off. Interface
must be restarted to take effect (see SYST:COMM:REST command).
Parameters:
<CPD>
Remarks:
Overlapped command
Value is not affected by reset
Example:
SYST:COMM:LAN:ADDR 192.168.001.100
SYST:COMM:LAN:ADDR? Response: 192.168.001.100
:SYSTem:COMMunicate:LAN:MASK
Syntax:
:SYSTem:COMMunicate:LAN:MASK <CPD>
:SYSTem:COMMunicate:LAN:MASK?
Description:
This command allows to change subnet mask if DHCP is switched off. Interface
must be restarted to take effect (see SYST:COMM:REST command).
Parameters:
<CPD>
Remarks:
Overlapped command
Value is not affected by reset
Example:
SYST:COMM:LAN:MASK 255.255.255.000
SYST:COMM:LAN:MASK? Response: 255.255.255.000
Betriebsanleitung
OCM642 Programmierbare Widerstandsdekade
Range 1 ... 31 (default 2)
Range 000.000.000.000
192.168.001.100)
Range 000.000.000.000
255.255.255.000)
... 255.255.255.255
... 255.255.255.255
(default
(default
52