orbit controls OCM642 Betriebsanleitung Seite 42

Orbit Controls AG
Remarks:
Overlapped command
Value is not affected by reset
Example:
PLAT:ZRES 100.0
PLAT:ZRES? Response: 1.000000E+02 OHM
[:SOURce]:RESistance[:AMPLitude]
Syntax:
[:SOURce]:RESistance[:AMPLitude] <DNPD>[<UNIT>]
[:SOURce]:RESistance[:AMPLitude]?
Description:
This command sets amplitude in Resistance mode. Node SOUR:RES also
selects "RESISTANCE" function if not already selected. Optionaly unit can be
enclosed.
Parameters:
<DNPD>
<UNIT>
·OHM
Remarks:
Overlapped command
Value is set to default after reset
Example:
RES 100.0
RES? Response: 1.000000E+02 OHM
[:SOURce]:TIMing:PAPPend
Syntax:
[:SOURce]:TIMing:PAPPend <SPD>
Description:
This command appends new preset into timing function. The new appended
preset has empty timing table and new records should be also appended (see
TIM:PRES<index>:RAPP). The new preset has its own index and can be
obtained by TIM:PCO command.
Parameters:
<SPD>
Remarks:
Overlapped command
Example:
TIM:PAPP "TIME2"
[:SOURce]:TIMing:PCOunt?
Syntax:
[:SOURce]:TIMing:PCOunt?
Description:
This command retreives actual number of timing presets. This number
represents maximum index used in preset commands.
Parameters:
<DNPD>
Remarks:
Overlapped command
Example:
TIM:PCO? Response: 1
Betriebsanleitung
OCM642 Programmierbare Widerstandsdekade
0.1 ... 10.0 e6, default 100.0
{OHM}
Quoted preset name. Upper alpha, lower alpha, digits and
spaces are allowable. Maximum string size is 10 characters.
Integer value representing preset count
42