dirna Bergstrom bycool green line COMPACT 3.0 Montageanweisungen Seite 30

COMPACT 3.0
EN
1- Connect the upper power cable in the rear of the unit and run to the back of the cabin, attaching the plastic
brackets and securing with flanges.
2- Connect the bottom power cable to the top power cable and run the unit's power cable to the short current
(positive) and mass point (negative) of the vehicle, attaching the plastic mounts at the back of the cabin
and securing with flanges; use the original cable run (inside the exhaust pipe protection (A)). (Clean the
area thoroughly before attaching the plastic mounts). When the unit is connected to the battery, this will
carry out a test of all the LEDs, displaying 88 GL-2 and then going off.
WHEN CONNECTING THE CABLES, BE SURE TO LEAVE SUITABLE DISTANCE IN ORDER TO
PREVENT BREAKAGE WHEN THE CABIN MOVES
Detailed instructions
on power wiring assembly
Wiring
supply
30
A
®