Yamaha REV7 Bedienungsanleitung Seite 21

CHECKING MIDI MEMORY
It's a good idea to keep a written record of your voice/effect
settings. However, you can easily check the REV's MIDI
memory without having to connect up your keyboard, in the
following manner: |
1. Press the REV7's MIDI CTRL key. Its LED will light.
2. Press the MEMORY key in order to call up the "PGM/
МЕМ" display on the LCD. |
3. You can now "scroll through" the REV7's MIDI memory,
_ by using the +/— keys: The PGM number will change, and
if a program number has a corresponding memory num-
ber, it will appear on the LCD, next to the "MEM"' sec-
tion. This will indicate the effect that has been selected to
go with the voice indicated in the "РСМ" section of the
LCD.
4. To check the parameter values of this effect, look it up in
the MEMORY (ROM) CONTENTS or USER PROGRAM
Chart, as appropriate. Or you can check it on the REV7
by pressing MIDI CTRL again, so that its LED goes out,
and the REV7 is in its normal operating mode. Then
select the effect in the usual way, and proceed to select
parameters.
CLEARING MIDI MEMORY
NOTE: These clearing operations affect ONLY the voice-
plus-effect couplings stored in the REV7's MIDI
memory, NOT the presets or edited user programs.
1. Press the REV7's MIDI CTRL key. Its LED will light.
2. Press the MEMORY key in order to call up the "PGM/
МЕМ" display on the LCD.
3. To clear a single voice/effect memory. Press CLEAR `
followed by STORE.
4. To clear the entire voice/effect memory. Press CLEAR
and STORE together.
5. You can now proceed to input further data into the MIDI
Memory, as previously described, or return the REV7 to
its normal operating mode by pressing the MIDI CTRL
key.
220