Werbung
Verfügbare Sprachen
Verfügbare Sprachen
NUMERIC
KEY RECALL
(All programs)
|
+ /- KEY RECALL
(All programs)
1. Press the MEMORY key (its LED will light).
REMOTE CONTROL RECALL
(Presets 1 — 30, User programs 31 — 37)
The RC7
remote control unit exactly reproduces the func-
tions of the Direct Recall keys marked REV1 thru 4, E/R1,
E/R2, and OTHERS. The USER MEMORY key performs a
similar function to the front panel USER MEMORY key.
Pressing
this
key
switches
the REV7
between
preset
programs and user programs, indicated by the LED's on the .
remote control unit. Of course, while the remote control unit
is connected to the REV7, the front panel controls on the
main unit may still be operated in the normal way.
(Note
that the remote control's LED's will be activated by corres-
ponding controls on the REV7's front panel).
The remote control unit is, therefore, a direct recall device,
and may be used for recalling the 30 presets and the first 7
user
programs,
as
previously
explained
in the
DIRECT
RECALL
section. So if you plan to use the remote control
unit, it's advisable to store your most needed user programs
in memory numbers 31 through 37.
You'll
also need
to set the
Input
Level, Parametric
EQ
Controls,
Mixing
Control
and
Output
Controls to your
desired setting, so that you don't need to touch the front
panel again during your performance or session.
A simple way to use the Remote Control Unit as a bypass
switch is by selecting an appropriate effect—one where the
level of the effect can be set at zero—and setting the relevant
parameter levels to zero so that you create a new program
that does not in fact alter the input signal. For example, -
select preset 7 (DELAY L, В) and set the delay level to 0%.
Store this edited program in a convenient.
memory number,
say 31. Then, when you select program 31 with your Remote
Control Unit, any previous reverb effect will be cancelled and
you will hear only your direct signal.
|
10
Werbung
