Parkside PBSA 20-Li A1 Originalbetriebsanleitung Seite 26

GB
may occur in connection with the type and
design of this power tool:
• Hearing damage if suitable ear protec-
tion is not worn.
• Health injuries resulting from the effect
of vibration on the hands and arms in
the event that the device is used over
a longer period of time or is not used
and maintained properly.
• Cutting injuries
WARNING! Danger due to electro-
magnetic field generated while the ma-
chine is in operation. Under certain cir-
cumstances, this field may negatively af-
fect active or passive medical implants.
In order to reduce the danger of serious
or fatal injuries, we recommend that indi-
viduals who wear medical implants should
consult their doctor and the manufacturer
of the implant before operating the ma-
chine.
Preparation
WARNING! Risk of injury due to
unintentional start-up. Only insert the re-
chargeable battery into the device once
the device is fully prepared for use.
Control elements
Familiarise yourself with the operating ele-
ments before using the device for the first
time.
• Rotation direction switch (5)
NOTICE! Only operate the direction of
rotation switch when the device is at a
standstill!
Direction of the switch as seen from be-
hind:
• Left screw in screw, drill
• Centre Switch lock
• Right unscrew screw
26
• Torque adjustment ring (3)
NOTICE! Betätigen Sie den Drehmo-
menteinstellring nur, wenn das Gerät
stillsteht!
Setting of the maximum torque for
screwing at which the slipping clutch is
disengaged.
• 1 lowest torque
• 21 highest torque
To be safe, start with a low torque
when screwing. Increase torque ac-
cording to requirement.
• drilling without torque limit
• On/Off switch (4)
• Switching on: Press
• Control the speed progressively: The
further you press the on/off switch,
the higher the speed.
• Switching off: Release
Attaching and removing the
attachment tool
Notes
• Size of drill chuck: 0.8–10 mm
• All directions viewed from behind.
Removing the attachment tool
1. Open the drill chuck: Turn the keyless
chuck (2) ⭯ .
2. Push the attachment tool as far as pos-
sible into the drill chuck opening (1).
Clamp the attachment tool: Turn the
keyless chuck (2) ⭮ .
Attaching the attachment tool
1. Open the drill chuck: Turn the keyless
chuck (2) ⭯ .
CAUTION! Risk of burn injury! The
2.
attachment tool – especially drills –
can become very hot. Wear protective
gloves whenever appropriate.
Remove the attachment tool.