Parkside PBSA 20-Li A1 Originalbetriebsanleitung Seite 25

6. SERVICE
a) Have your power tool serviced
by a qualified repair person us-
ing only identical replacement
parts. This will ensure that the safety
of the power tool is maintained.
b) Never service damaged bat-
tery packs. Service of battery packs
should only be performed by the man-
ufacturer or authorized service pro-
viders.
Safety information for drills
Safety instructions for all
operations
• Hold the power tool by insu-
lated gripping surfaces, when
performing an operation where
the cutting accessory or fasten-
ers may contact hidden wir-
ing. Cutting accessories or fasteners
contacting a "live" wire may make ex-
posed metal parts of the power tool
"live" and could give the operator an
electric shock.
Safety instructions when using
long drill bits
• Never operate at higher speed
than the maximum speed rat-
ing of the drill bit. At higher
speeds, the bit is likely to bend if al-
lowed to rotate freely without contact-
ing the workpiece, resulting in personal
injury.
• Always start drilling at low
speed and with the bit tip in
contact with the workpiece. At
higher speeds, the bit is likely to bend if
allowed to rotate freely without contact-
ing the workpiece, resulting in personal
injury.
• Apply pressure only in direct
line with the bit and do not ap-
ply excessive pressure. Bits can
bend causing breakage or loss of con-
trol, resulting in personal injury.
Additional safety instructions
• Secure the workpiece. A work-
piece clamped with clamping devices
or in a vice is held more secure than by
hand.
• Switch the power tool off imme-
diately if the application tool
becomes blocked. Be prepared
for high torque reactions which
cause kickback. The application
tool becomes blocked when it becomes
jammed in the workpiece or when the
power tool becomes overloaded.
• Always wait until the power
tool has come to a complete
stop before placing it down. The
application tool can jam and cause
you to lose control of the power tool.
• Hold the power tool securely.
When tightening and loosening screws
be prepared for temporarily high
torque reactions.
• Use suitable detectors to de-
termine if there are hidden sup-
ply lines or contact the local util-
ity company for assistance. Con-
tact with electric cables can cause fire
and electric shock. Damaging gas lines
can lead to explosion. Breaking water
pipes causes property damage.
• Only use accessories recom-
mended by PARKSIDE. Unsuitable
accessories may cause electric shock
or fire.
Residual risks
There will always be residual risks even
if you operate this power tool according
to the instructions. The following hazards
GB
25