Parkside PBSA 20-Li A1 Originalbetriebsanleitung Seite 141

The charge level of the battery is indic-
ated by illumination of the correspond-
ing LED lights.
red, orange and green
Battery charged
red, orange
Battery partially charged
red
Battery needs to be charged
2. Charge the battery (3) when only the
red LED on the level indicator (2) is illu-
minated.
Inserting and removing the
battery
WARNING! Risk of injury due to
unintentional start-up. Only insert the re-
chargeable battery into the device once
the device is fully prepared for use.
NOTICE! Risk of damage! An incorrect
battery can damage the device and bat-
tery. An up-to-date list of battery compatib-
ility can be found at: www.lidl.de/akku
Inserting the battery
1. Push the battery (3) along the guide in-
to the battery holder.
You will hear the battery click into
place.
Removing the battery
1. Press and hold the battery release (4)
on the battery (3).
2. Pull the battery out of the battery hold-
er.
Operation
Control display
Meaning of the control display (5):
Display Meaning
Perman-
stand-by (No battery inser-
ent light
ted)
Battery is fully charged
Slow
Battery is charging
flashing
Fast flash-
Error
ing
• Battery not recognized
• Temperature too high
or too low
Charging the battery
NOTICE! Risk of injury due to electric
shock. Charge the battery in a dry room
only. Prior to attaching the charger, check
that the battery's outer surface is clean
and dry.
Hinweise
• Allow a hot battery to cool before char-
ging.
Akku aufladen
1. Remove the battery (3) from the device,
as necessary.
2. Insert the battery (3) into the charging
slot (6).
3. Plug the battery charger (1) into a
mains outlet.
4. When the battery is fully recharged un-
plug the battery charger (1) from the
mains.
5. Remove the battery (3) from the char-
ging slot (6).
GB
23