Werbung
Verfügbare Sprachen
Verfügbare Sprachen
- for all maintenance and clean-
ing work,
- if the connecting cable is dam-
aged or tangled up.
• Never use the mains lead to pull
the plug out of the socket or to
pull the appliance. Protect the
cable from heat, oil, and sharp
edges.
• Make sure that the mains volt-
age corresponds with the infor-
mation on the rating plate.
• Only plug the appliance into a
socket which is safeguarded.
• The device must only be con-
nected to a mains socket via a
residual-current circuit breaker
(RCD) with a rated leakage cur-
rent of not more than 30 mA.
• Do not expose the unit to rain
CAUTION! The following
states how damage to the
appliance and possible inju-
ry to people can be avoided:
• Ensure that the machine is cor-
rectly assembled and the filters
are in the correct position.
• Do not use without the filter. This
could damage the machine.
• Only use replacement parts
and accessories delivered and
recommended by our Service
Centre. The use of parts by
other manufacturers immediately
renders the guarantee void.
• Only have repairs carried out at
our authorised customer service
points.
• Observe the instructions for
cleaning and maintenance of
the machine.
• Store the appliance in a dry
place and out of reach of chil-
dren.
Assembly
Pull out the mains plug.
Danger of electric shock.
1. Attach the castors (8) with accessory
holders (8a) to the underside of the
container (7).
2. Place the motor housing (4) on top of
the container (7) and close it with the
clips (6).
The motor head (4) can only be placed
in one position on the container (7).
The air flow control (3) and the device
socket (11) must be above the suction
connection (10). The water duct con-
nector (5) must be above the suction
connector (10).
3. Installing the accessories:
- Push the vacuum hose (16) into the
suction connection (10) until it locks
in place.
To remove it, press the catch (18)
and pull the vacuum hose (16).
- Press the water duct button on the
suction hose (17) and slide it onto
the water duct connector (5).
- Press the water tank (19) into the
holders on the back of the motor
head (4) and the container (7).
- Assemble the suction pipes (14).
Make sure to connect the water
channels (13+17) correctly. To disas-
GB
MT
21
Werbung
