Cleaning The Exhaust Air Filter; Storage - Cleanmaxx 09200200100 Gebrauchsanleitung

9. After drying, place the foam filter back into the HEPA filter and place it into the cyclone
insert. PLEASE NOTE: Do not place the cyclone insert, HEPA filter and foam
filter into the dust container if one of the components is still damp!
10. Place the cover on the dust container and rotate it as far as it will go.
11. Place the dust container into the device.
If the HEPA filter is damaged or worn, you can order a new filter at:
www.service-shopping.de

cleaning the Exhaust Air Filter

The exhaust air filter is located on the rear of the vacuum cleaner behind a protective grille. It
filters the air as it leaves the vacuum cleaner and before it is returned to the ambient air. Clean
the exhaust air filter from time to time.
1. Press the button in the middle of the protective grille and remove the grille.
2. Take the holder of the exhaust air filter out of the device and the exhaust air filter out of
the holder.
3. Tap the exhaust air filter out over a dustbin. If necessary, you can also clean it with clear,
lukewarm water. Then shake off any excess water and let the filter dry completely in the air.
PLEASE NOTE: Never install the filter as long as it is still damp!
4. Brush off or wipe down the exhaust air filter compartment if necessary.
5. Place the exhaust air filter into the holder and the holder back into the filter compartment.
6. First engage the protective grille in the recesses at the bottom of the filter compartment,
then fold it until it engages.

Storage

• For practical storage purposes, you can hook the floor nozzle into the bracket on the back
of the device and collapse the telescopic tube as far as possible.
• Store the vacuum cleaner in a cool, dry indoor room that is inaccessible to children and pets.
09200_DE-GB-FR-NL_V1.indb 27
27
21.11.12 15:34