Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
MT
Setting the planing table
0
Chip removal, surface planer
1
2
Working direction
Working direction
Planing width, max. 204 mm
max
204 mm
Scale, thicknesser
Remove before use!
Remove the cross struts before use.
Note before initial start-up!
Assembly note:
1. Remove cross struts for securing the
tables for transport.
2. Before assembling the collection
container, remove the plug from the
mains socket!
3. Thicknessing: Remove the jointing
fence – place the collection contain-
er on the jointer tables
4. Surface planing: Move the thickness-
ing table to the bottom position –
insert the collection container on the
thicknessing table into the machine
5. The collection container is in the cor-
rect position when the two locks can
be inserted into the jointer table
Important: The two locks must be insert-
ed up to the stop as otherwise the limit
switch located on the inside will not be ac-
tuated and the machine cannot be started.
26
Symbols used in the instruction
manual:
Hazard symbol with infor-
mation on the prevention of
personal injury or property
damage
Hazard symbol with information on
damage prevention
Pull out the mains plug.
Advisory symbol with information
on how to best use the device
General safety instructions
Attention! The following basic
safety precautions must be ob-
served while using power tools to
protect against electric shock, injury
and risk of fire:
There is a risk of injuries.
General Safety Instructions
for Power Tools
WARNING! Read all safety
instructions and guidelines
carefully.Failure to follow the
safety instructions and guidelines
may result in electric shock, fire
and/or serious injuries.
Save all safety instructions and
guidelines for the future.
The term "power tool" used in the safe-
ty instructions refers to mains-operated
electric tools (with a mains cable) and to
battery-operated electric tools (without a
mains cable).
Werbung
