Entering The N° Of Cycles; Entering The New Code; Saving The New Code; Locking" Of Machine Function - Fronius Magic Wave 2600 Fuzzy Bedienungsanleitung

4.3 ENTERING THE N° OF CYCLES
- Here you can decide how often (i.e. after how many times of switching-
on and switching-off) you want the machine to request the code
- You can set any number of cycles between 1 and 50
Display
A V
C Y C 2 2 2

4.4 ENTERING THE NEW CODE

- You may use any combination of figures („0-9") and letters („A-H") for the
code
Display
A V
C o d 1 - -
C o d - A -
C o d - - 3

4.5 SAVING THE NEW CODE

Display
A V
P r o 2 2
- Before the new code is saved, the machine asks you to enter it again.
This is to ensure that you have remembered or made a note of the new
code
Display
A V
C o d 1
C o d A
C o d 3
- After you have entered the code, this is saved. This code combination is valid from this time onward, i.e. every time the machine asks for the code,
this new combination is the one you must tell it.
4.6 „LOCKING" OF MACHINE FUNCTION
- If three incorrect attempts are made to enter the code when the machine
requests the code, all functions are locked and „LOC" appears on the
left-hand display . Switch the machine off and on, and enter the
correct code.
Display
A V
L O C
Entry of desired n° of cycles
Use the torch trigger to enter the desired number of cycles
Entry of new code combination
Enter the „hundreds" digit of the new code
Enter the „tens" digit of the new code
Enter the „units" digit of the new code
Saving new code
Code is verified
Verification of new code combination
Enter the „hundreds" digit of the new code by pressing the
torch trigger
Enter the „tens" digit of the new code by pressing the torch
trigger
Enter the „units" digit of the new code by pressing the torch
trigger
Verification of new code combination
All machine functions are „locked" and cannot be used.
- e.g.: 1...... The machine requests the code after every time of swit-
ching-on
e.g.: 5...... The machine requests the code after every 5 times of
switching off and on again
- Use the torch trigger to enter the code
- If the code has been deactivated, the machine does not request the
code. The internal factory settings are saved
- If, when the new code is verified (see chap. 4.5), you enter an incorrect
code combination 3 times in succession, all machine functions will be
„locked". The only way you can activate the machine is to switch it off and
on again at the mains switch
change remains valid.
13
Continue with
Function button
Continue with
Function button
Function button
Function button
Continue with
Function button
Continue with
Function button
Function button
Function button
. The code combination saved before the
Continue with
Switch the machine off and on
again at the mains switch