Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Troubleshooting
Possible cause
Electrical connection incorrect e.g. Phase
rotator.
Error in the drive controller.
6.2 Product does not achieve the cycle times
Possible cause
Attachments on the product have too much
mass.
Specifications made by control unit are not
correct.
Error in the drive controller.
6.3 Product gets too hot
Possible cause
Temperature sensor not connected properly.
Attachments on the product have too much
mass.
Error in the drive controller.
6.4 Pneumatic signals are not transmitted?
Possible cause
Pressure lines connected incorrectly.
Pneumatic rotary feed-through has exceeded
its life span
6.5 Electrical signals are not transmitted?
Possible cause
Cable connected incorrectly.
Bus signals should be transmitted.
Electrical rotary feed-through has exceeded
its life span
64
6 Troubleshooting
6.1 Product does not move
Corrective action
Electrical connection according specifications
e.g. carry out circuit diagram.
See documentation for drive controller.
Corrective action
Check cycle time calculation.
Correct specifications.
See documentation for drive controller.
Corrective action
Check electrical connection.
Check cycle time calculation.
See documentation for drive controller.
Corrective action
Check connection.
Contact the SCHUNK contact person.
Corrective action
Check electrical connection.
Bus signals cannot generally be transmitted.
Please get in touch with your SCHUNK contact
person.
Contact the SCHUNK contact person.
10.00 | ERD | Assembly and operating manual | de en | GAS 315325
Werbung
