Jacuzzi profile Bedienung Und Wartung Seite 22

Steady colours
You can also choose from the following colours, which appear
in stable fashion: white, light blue, orange, yellow, green.
Setting the time
For correct management of the water filtering and use of the
energy savings mode, the current time must be set.
13.30
Light
Clock
Press the "Clock"
time will be displayed, the hour digit will flash, and the respec-
tive symbol will appear on the display.
Use the keys "Up"
Hold the keys down for rapid change.
Then press the "Clock"
will start flashing.
Proceed as described previously.
Press the "Clock"
and exit programming mode.
NOTES
- If no key is pressed for 5 seconds, you will exit the proce-
dure and any settings will not be memorized.
Displaying the time
To display the time, press the "Clock"
AM
Filter Blower Pump 1
Instant Clear Econo Pump 2
key for about 5 seconds. The current
and/or "Down" to set the hour.
key to set the minutes, which
key again to memorize the set values
key.
Water filtering
Filtering, obtained through the combined action of a specific
pump and a cartridge filter, is indispensable to keep the wa-
ter clean and transparent, and to eliminate particles in sus-
pension. This action is further improved by the UV light gen-
erator (Clearray™) , which helps oxidize the organic substances
that infiltrate the water and therefore reduces the need for
chemical products for water treatment.
Clearray™ operates automatically and is dependent on pump
activation; it remains off when the hydromassage, blower or even
just the spotlight are on, as it is presumed that there is some-
body in the tub. Clearray™ (where a filtering cycle is active) be-
gins operating once again 10 minutes subsequent to switching
Up
off the aforementioned functions.
Down
NOTE: even if a filtering cycle is not active, when you turn on
the hydromassage, the blower or even just the spotlight, the
filtering pump is automatically started, since presumably there
are persons in the tub resulting in suspended particles which
may decrease water quality. The filtering pump runs for 10
minutes after the functions are turned off.
Filtering occurs during a cycle that is run every 12 hours.
Setting the filtering cycles
To set the filtering cycle:
Press the key "Filter"
Fdx, where "x" indicates the duration in hours.
Use the keys "Up"
sired duration. This may be from a minimum of 0 to a maximum
of 12 hours, which corresponds to constant filtering, since
the cycle runs every 12 hours in any case.
Press the "Filter"
ue. You will then go to the start time (Fs).
22
Filter Blower Pump 1
Instant Clear Econo Pump 2
. The display shows the message
and/or "Down" to insert the de-
key again to confirm the selected val-
Up
Down