Jacuzzi profile Bedienung Und Wartung Seite 24

Maintenance of minimum temperature of water in tub and
anti-freeze protection of the pipes ("Smart Winter").
The system software of your Profile spa is designed to pro-
vide efficient, rational management of any hazardous situations
which may occur due to excessively cold temperatures and freez-
ing of the water.
For further information on water heating and system safe-
guards, refer to the product's installation manual.
NOTE: when the anti-freeze protection is active, the display will
show the message ICE.
ABNORMAL OPERATING CONDITIONS
ALARM SIGNALS
If there is an alarm, this is indicated on the display, with the cor-
responding code.
You will continue to see the code if the alarm condition persists.
Here is a list of the various alarms that may appear. Refer to the
product's installation manual for a detailed description of the var-
ious messages that may appear on the display.
"FLC"
In some models, the initials "FLC" may appear on the display.
- Contact an authorized Jacuzzi
"FLO" (flashing)
The heater is not turned on.
- The system attempts to reactivate the heater three times.
"FLO" (stable)
The heater cannot be turned on.
Try turning the switch up the line from the spa off and back on; if
the signal stays on, contact an authorized Jacuzzi
"HOH" The measured temperature at the heater is 48 °C
(118 °F) or higher.
DO NOT ENTER THE WATER
- If the alarm condition persists, even though the temperature has
dropped back below 44°C, try turning the switch up the line from
the spa off and back on. If the signal stays on, contact an author-
ized Jacuzzi ® service centre.
"Ho" Excessive water temperature.
DO NOT ENTER THE WATER
- If present, remove cover from spa.
- If the excessive temperature increase is due to sunlight, add cold
water to the spa.
When the temperature has dropped to below 43 °C (109 °F), the
spa should re-activate automatically. If it does not, disconnect the
power supply and contact an
"rPF" Defective temperature probe
DO NOT ENTER THE WATER
It is not possible to activate any function.
- Contact an authorized Jacuzzi
® service centre.
® service centre.
authorized Jacuzzi ® service centre.
® service centre.
"HPF" Activation of safety thermostat (electric heater can-
not be turned on).
- Try turning the switch up the line from the spa off and back on
(system reset). If the signal stays on, contact an authorized Jacuzzi
service centre.
"cErr" The system has been locked.
- Make sure that you have not left the compensation tank drain open.
- Try turning the switch up the line from the spa off and back on
(system reset). If the signal stays on, contact an authorized Jacuzzi
service centre.
24
®
®