Basler BIP2-DXXXXc-dn Models Installationsanleitung Seite 32

Installation Guide
5 Complete the Installation
1. Install the desiccant pack (outdoor dome cameras only):
a. Get the desiccant pack, cable tie, and stick-on cable tie anchor from the
installation kit (the desiccant pack will be in a foil wrapper).
Cable Tie
b. Place the stick-on anchor on the camera base as shown below.
Remove the desiccant pack from its foil wrapper, cable tie the desiccant
to the anchor, and clip off the end of the cable tie.
30
Stick-on Cable
Tie Anchor
AW00101404000
Desiccant Pack
(in foil wrapper)
Install Desiccant
Pack Here
Cable Tie End
Basler IP Fixed Dome Cameras
Clip Off