Basler BIP2-DXXXXc-dn Models Installationsanleitung Seite 31

AW00101404000
2. Check the focused image on the Live Stream tab.
If necessary, you can readjust the focus stepwise:
3. For this purpose, open the Focus tab in the Image Controls group, if it has
not already been opened.
4. Use the Focus Move buttons to move the lens in fine (>), medium (>>), or
coarse (>>>) steps to readjust the focus towards near (N) or far (F).
The One Push Focus command is used to focus on the object/s of interest only
once. (No automatic refocusing during operation.)
Note that the quality of the focusing result might be influenced by:
object movements during the focusing process

 changes in lighting conditions
low lighting level

 low temperature
(See the note on the limited temperature range for the installation of
autofocus dome cameras as indicated on page 27.)
low optical contrast (e.g. a white wall)

 contaminated lens
Basler IP Fixed Dome Cameras
Installation Guide
29