Neoss NeoScan 1000 Installations- Und Bedienungsanleitung Seite 30

8. Acquiring a 3D model using
the preparation workflow
Depending on your workflow preferences, you can use the preparation workflow. This workflow provides you with
two choices:
• You can scan the tooth before preparing, and then take another scan after the tooth is prepared.
• You can import the previously saved data before preparing, and then start to scan the preparation.
With either option, two 3D models will be created after the scan is completed: one containing the unprepared
tooth and the other containing the preparation. You or the lab can use these 3D models for restorations to make
them closely resembles the original tooth.
The following steps describe how to combine the previous scan with the new scan of the preparation.
• Import the scanned data before preparing
• Scan the preparation areas
• Refine and check the 3D model.
• Complete and save the 3D model.
Import the scanned data before preparing
1. Click the Option menu
2. Select the .scan file you want to import, and click Open. Wait for the software to import the data, and the 3D
model will be displayed after the import is complete.
3. Click the Mark tooth
ball will display on the occlusal surface indicating a preparation area.
4. Rotate the 3D model if necessary, and mark all the preparation areas.
You can click and hold the middle mouse button to rotate the 3D model
when using tools such as Cut
5. Click the Return
30 NeoScan 1000 Installation and Operation Manual
button and select Import scan data.
button, and then click in the center of the occlusal surface of the preparation. A 3D
, Lock
button to quit Mark tooth tool.
and Mark tooth .