Neoss NeoScan 1000 Installations- Und Bedienungsanleitung Seite 27

Installing and scanning the scan body
After installing the scan body, follow the steps below to scan the scan body:
• After making the implant areas, click the Config Scan button at the bottom of the NeoPro interface.
• Click the Add scan body button in the pop-up window.
• Click the Scan Body button below.
• Check whether the part that the software automatically cut out from the implant areas is sufficient to contain
the diameter of the scan body. If the cut out part is not enough to contain the scan body, you can click the
Cut button, and cut off the necessary part to cover the scan body. In order to avoid the situation that the
NeoScan 1000 Installation and Operation Manual 27