Neoss NeoScan 1000 Installations- Und Bedienungsanleitung Seite 23

Completing and saving the 3D model
To complete the scan and save the 3D model, follow these steps:
• Click the Finish
the previous step, it will be displayed on this page.
• Complete the patient information, if necessary, you can add some attachments to the case.
• Click the Upload to cloud
• Click the Save to file system
7. Acquiring a 3D model using
the scan body workflow
You can use the scanner to scan all or part of the dental arch containing the abutment or implant and create a 3D
model. When using an existing abutment to scan all or part of the dental arch, use the "common scan" workflow.
When you scan all or part of the dental arch that contains the implant, the scan body workflow is used. When
using the scan body workflow, the software will copy the 3D model and automatically cut out the implant areas,
rescan the tooth jaw with the scan body and create two 3D models: one contains the scan body and the other
does not contain the scan body. The user can send these models to the dental laboratory.
In some cases, you can acquire 3D models of a single arch (partial or full)
and not obtain a buccal bite registration (for example, if there are no
teeth in the opposing arch), but it is recommended that you acquire both
arches and a buccal bite registration when possible.
To acquire a 3D model for an implant, follow these steps:
• Scan the upper and lower jaw.
• Scan the buccal bite registration.
• Mark the implant areas
• Install and scan the scan body
• Refine and check the 3D model.
• Complete and save the 3D model.
button and the following page will be displayed. If you entered patient information in
button to upload the case and 3D model data to NeoConnect.
button to save the case and 3D model data to the specified local directory.
NeoScan 1000 Installation and Operation Manual 23