Neoss NeoScan 1000 Installations- Und Bedienungsanleitung Seite 25

If you need to remove soft-tissue artifacts, mismatches, or unwanted views during the acquisition, click the
Cut tool, then draw a curve that covers the region to be removed on the 3D model. If necessary, rescan
the area to fill the holes.
• After scanning the upper jaw, you can continue scanning the lower jaw. On the NeoPro interface, select the
Lower Jaw acquisition mode
OR
Press the mode button on the scanner to select the lower jaw scan mode
• Repeat steps 3 to 6 until the lower jaw scan is completed.
• Check whether there are obvious holes on the 3D model and rescan if necessary.
• When you confirm that the 3D model of the upper and lower jaw is complete, continue with the buccal bite
registration acquisition.
Scanning the buccal bite registration
To acquire a buccal bite registration, follow these steps:
• On the NeoPro interface, select the Buccal Bite Registration
OR
Press the mode button on the scanner to select the buccal bite registration mode
• Place the tip of the scanner into the buccal side in the patient's mouth, then rotate the tip to align with the
teeth, close the patient's mouth and confirm that the bite position is correct.
• Press the Start Scan button, slowly move the scanner tip in mesial direction with equal coverage of upper and
lower teeth.
.
acquisition mode
.
NeoScan 1000 Installation and Operation Manual 25