Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6. Acquiring a 3D model using
the common scan workflow
The common scan workflow (default workflow) allows you to scan either a partial or full arch. For either type of
scan, you should scan upper jaw, lower jaw, and buccal bite registration. Once this basic information has been
scanned, other scan types (such as scan body scanning) can be used to acquire other information.
For example, use a general scanning workflow to scan a 3D model for orthodontics. Scan the complete dental arch
to create a 3D model. The user should scan the upper jaw, lower jaw, and buccal bite registration, as well as
images of a few millimeters of gum tissue in the lingual and buccal scans. The software will combine these images
to create a 3D model, which can then be uploaded to NeoConnect or saved locally.
In some cases, you can acquire 3D models of a single arch (partial or full)
and not obtain a buccal bite registration (for example, if there are no
teeth in the opposing arch), but it is recommended that you acquire both
arches and a buccal bite registration when possible.
To acquire a 3D model, follow these steps:
• Scanning the upper and lower jaw.
• Scan the buccal bite registration.
• Refine and check the 3D model.
• Complete and save the 3D model.
Scanning the upper and lower jaw
To scan a 3D model of the upper and lower jaw, follow these steps:
• Dry the teeth thoroughly before starting an acquisition.
• On the NeoPro interface, select the Upper Jaw
OR
Press the mode button on the scanner to select the upper jaw scan mode
• Place the tip of the scanner on the surface of the tooth to stabilize the scanner and press the Start Scan button.
Wait until a 3D image appears on the 3D model display screen, and then slowly move it along the arch at
0-5mm from the teeth. The image will be automatically scanned and displayed on the 3D model display area.
acquisition mode
NeoScan 1000 Installation and Operation Manual
.
19
Werbung
