Silvercrest SGBR 1500 D4 Bedienungsanleitung Seite 73

NOTE
► As a general rule, if you are baking or grilling
with hot air you can dispense with a preheating
of the grilling/cooking space .
–
Use the timer 4 to set the preheat time
(approx . 10 minutes) .
–
Close the glass door 6 .
4) Once the warm-up period is finished, place
the foodstuffs on the rack e or the baking
tray q and slide it in on one of the rails .
Ensure that there is sufficient space between
the foodstuffs and the inner walls/heating
elements of the appliance .
NOTE
► If you wish to prepare food on the rack e
that drips excessively, then slide the baking
tray q onto the bottom rail . By doing this,
dripping fat for example will be caught and
the appliance is then easier to clean .
5) Close the glass door 6 before starting the
grilling or baking process .
6) If required, use the timer 4 to set the required
grilling or baking time . You can set a maximal
grilling/baking time of 120 minutes using the
timer 4 . Alternatively, you can set the timer 4
to the "ON" position to run the appliance for
an unlimited period .
NOTE
► If the cooking time for the food is less than
20 minutes, first set the timer 4 to 40 minutes
and then turn it back to the required grilling
or baking time .
The control lamp 5 indicates that the appliance is
now switched on . If you pre-set a baking time, the
dial of the timer 4 will move towards the "OFF"
position .
■ 70 │ GB │ MT
The appliance switches off automatically after the
set period (if any); there is a beep and the control
lamp 5 goes out .
NOTE
If you want to interrupt the heating process
prematurely, turn the temperature control 2
counter-clockwise to the stop and set the timer 4
to "OFF " .
7) If you do not pre-set a baking time, you can
manually stop the heating process by moving
the timer 4 to "OFF" .
8) After cooking, remove the rack e or the baking
tray q using the tongs 0 .
9) Set the function switch 3 to "OFF" .
Grilling with the rotisserie
1) Put the crumb tray 7 into the appliance .
2) If inserted, remove the rotisserie z from the
appliance .
3) Push the baking tray q onto the lower rail .
4) Fix the food to be grilled with the skewer
clamps t . Ensure that the food in the cooking
chamber can turn freely without touching the
sides . The rotisserie z may change its direction
of rotation if the food strikes against a resistance .
The two depressions on the rotisserie z must re-
main freely accessible, otherwise you will not be
able to grasp the rotisserie z with the tongs w .
5) Fit the rotisserie z in the cooking chamber
(see chapter "Using the rotisserie")
6) Close the glass door 6 .
SGBR 1500 D4