Using the rotisserie
WARNING! RISK OF INJURY!
►
Always use the tongs w to insert the hot rotis-
serie z into the appliance or to remove it .
■
You can use the two skewer clamps t to fix the
food onto the rotisserie z . Loosen the restrainer r
on the skewer clamps t, push them so that the
food is fixed firmly in between the clamps and
then screw the restrainer r tight again .
■
First push the end of the rotisserie z without the
notch into the drive 1 (Figure 1):
Fig . 1: Push the rotisserie z into the drive 1 .
■
Then insert the other end of the rotisserie z with
the deep groove in the spit fitting 9 (Figure 2):
Fig . 2: Insert the rotisserie z in the spit fitting 9 .
SGBR 1500 D4
NOTE
►
Always slide the baking tray q into the lower
rail when you use the rotisserie z .
This will collect any drips .
■
To remove the hot rotisserie z, grip with
the hooks at the end of the tongs w into the
recesses on the rotisserie z (Figure 3):
Fig . 3: Hooking the tongs w onto the rotisserie z
■
First lift the left-hand side of the rotisserie z out
of the spit fitting 9 and then pull the rotisserie z
from the drive 1 .
GB │ MT
│
67
■