To Set The Product In Transport Position - Husqvarna 2-48DS Bedienungsanweisung

• The wheels let you move the product shorter
distances. For longer distances, lift the product to
move it or put the product on a vehicle.
• Put some type of protection on the product
during transportation. The protection keeps natural
elements such as rain and snow away from the
product.
• Engage the drive system during transportation. Refer
to To engage the drive system on page 10 .

To set the product in transport position

WARNING:
the blast wheels have fully stopped.
1. Disengage the drive system. Refer to
the drive system on page 12 .
2. Put a lever in the lift mechanism.
3. Push down on the lever to lift the product into
transport position.
To move the product manually
WARNING:
are stationary before you move the product.
WARNING:
steel toe-cap and non-slip sole.
WARNING:
up and down ramps manually with the drive
system disengaged. Only move the product
manually on level ground.
1. Set the product in transport position. Refer to
the product in transport position on page 26 .
2. Disengage the drive system. Refer to
drive system on page 10 .
26
Do not lift the product until
To disengage
Wait until all moving parts
Use protective boots with
Do not move the product
To set
To engage the
3. Push the handle down.
4. Push or pull the product by the handle.
5. Engage the drive system. Refer to
drive system on page 10 . With the motor off, this
has the function of a parking brake and prevents
accidental movement of the product.
To move the product with the drive
system
WARNING:
there is a risk of injury if the product falls. Be
careful when you move the product.
WARNING:
the ground during operation.
WARNING:
forward during operation.
WARNING:
steel toe-cap and non-slip sole.
1. Engage the drive system. Refer to
drive system on page 10 .
To engage the
The product is heavy and
Do not lift the product of
Do not move the product
Use protective boots with
To engage the
2118 - 001 - 27.06.2023