Husqvarna 2-48DS Bedienungsanweisung Seite 19

8. Make sure that the hotspots are equally applied on
the surface for correct adjustment.
9. Tighten the control cage clamps and install the cage
clamp plate when the control cage is in correct
position.
10. Attach the feed spout.
To stop the product
1. Push the control levers for the abrasive material to
close the valves for the abrasive material. Refer to
To operate the valves for the abrasive material on
page 12 .
2. Push the OFF button (A) to stop the blast motors.
B
2118 - 001 - 27.06.2023
3. Push the OFF button (B) to de-energize the control
4. Turn the ON/OFF switch to OFF position.
5. Disconnect the power plug from the power supply.
6. Stop the dust collector. Refer to the operator's
A
panel.
manual of the dust collector.
19