Husqvarna 2-48DS Bedienungsanweisung Seite 18

2. Remove the feed spout.
3. Remove the cage clamp plate (A) and loosen the
control cage clamps (B).
B
A
4. Examine the position of the control cage window.
5. Look at the blast pattern from the front of the
product.
18
6. Turn the left control cage clockwise if the hotspot is
too much in the middle. Turn the right control cage
counterclockwise if the hotspot is too much in the
middle.
7. Turn the left control cage counterclockwise if the
hotspot is too much on the left side. Turn the right
control cage clockwise if the hotspot is too much on
the right side.
2118 - 001 - 27.06.2023