Husqvarna 2-48DS Bedienungsanweisung Seite 9

• Make sure that the extension cable is out of the
way and the product during operation. This prevents
damage to the extension cable.
Safety devices on the product
WARNING:
instructions that follow before you use the
product.
• Do not use a product with safety devices that are
damaged or do not operate correctly.
• Do a check of the safety devices regularly. If the
safety devices are damaged or do not operate
correctly, speak to your Husqvarna service agent.
• Do not make modifications to safety devices.
Emergency stop button
The emergency stop button is used to quickly stop the
motors.
To do a check of the emergency stop button
Control panel on page 4 for information about
Refer to
where the emergency stop button is on your product.
1. Turn the emergency stop button clockwise to make
sure that the emergency stop button is disengaged.
2. Start the product. Refer to
page 16 .
3. Push the emergency stop button.
4. Make sure that the motors stop.
5. Turn the emergency stop button clockwise to
disengage.
Ammeters
The ammeter shows the blast load onto the surface. The
maximum amperage is shown above the ammeters.
To do a check of the ammeters
Control panel on page 4 for information about
Refer to
where the ammeter is on your product.
1. Start the product. Refer to
page 16 .
2. Wait until the ammeters are in idle position.
3. Stop the product. Refer to
page 19 .
ON/OFF buttons for the blast motors
The ON/OFF buttons for the blast motors are used to
start and stop the blast motors. Refer to
of the ON/OFF buttons for the blast motors on page 9 .
2118 - 001 - 27.06.2023
Read the warning
To start the product on
To start the product on
To stop the product on
To do a check
To do a check of the ON/OFF buttons for the blast
motors
Control panel on page 4 for information about
Refer to
where the ON/OFF buttons are on your product.
1. Turn the emergency stop button clockwise to make
sure that the emergency stop button is disengaged.
2. Start the product. Refer to
page 16 .
3. Push the ON button for the blast motors.
4. Make sure that the blast motors start and the
indicator comes on. Refer to
4 .
5. Stop the blast motors. Refer to
on page 19 .
6. Make sure that the blast motors stop when you push
the OFF button.
ON/OFF buttons of the control panel
The ON/OFF buttons of the control panel are used to
engage and disengage the control panel.
To do a check of the ON/OFF buttons of the control
panel
Control panel on page 4 for information about
Refer to
where the ON/OFF buttons are on your product.
1. Turn the emergency stop button clockwise to make
sure that the emergency stop button is disengaged.
2. Turn the ON/OFF switch to ON position.
3. Push the ON button of the control panel.
4. Make sure that the indicator lamp of the control
panel comes on.
5. Push the OFF button of the control panel. Make sure
that the indicator lamp goes off.
6. Turn the ON/OFF switch to OFF position.
ON/OFF switch
The ON/OFF switch is used to start and stop the power
supply to the product.
To do a check of the ON/OFF switch
Control panel on page 4 for information about
Refer to
where the ON/OFF switch is on your product.
1. Turn the emergency stop button clockwise to make
sure that the emergency stop button is disengaged.
2. Turn the ON/OFF switch to ON postion.
3. Make sure that the power supply starts.
4. Turn the ON/OFF switch to OFF position.
5. Make sure that the power supply stops.
To start the product on
Control panel on page
To stop the product
9