Husqvarna 2-48DS Bedienungsanweisung Seite 12

7. Close the drive chain cover.
8. To disengage the drive system, refer to
disengage the drive system on page 12 .
To disengage the drive system
CAUTION:
system when the product is parked on a
level surface.
If it is necessary to move the product manually with the
motors off, the drive system must be disengaged.
1. Park the product on a level surface and stop the
To stop the product on page 19 .
product. Refer to
2. Disconnect the power supply.
3. Open the drive chain cover.
A
4. Pull out the quick-release pin (A).
5. Put the quick-release pin in the storage position (B).
12
To
Only disengage the drive
B
6. Close the drive chain cover.
Valves for the abrasive material
The valves for the abrasive material control the flow of
the abrasive shots to the blast wheels. The adjustment
of the valves for the abrasive material is shown on the
Control panel on page 4 .
ammeters. Refer to
The valves for the abrasive material are adjusted with
the control levers for the abrasive material. Refer to
operate the valves for the abrasive material on page
12 .
To operate the valves for the abrasive
material
CAUTION:
abrasive material when the blast motors are
in operation.
1. Pull down the 2 control levers for the abrasive
material (A) and (B) at the same time to open the
valves for the abrasive material.
A B
2. Read the values on the ammeters.
Only open the valves for the
2118 - 001 - 27.06.2023
To