To Clean The Product - Husqvarna 2-48DS Bedienungsanweisung

General product maintenance
Do a check of the drive chain tension of
the drive system.
Clean the drive chain of the drive system.
Do a complete servicing and cleaning of
the product.

To clean the product

• Always clean all the equipment after use. Use a
vacuum cleaner.
• Do not use a high-pressure washer to clean the
product.
• Keep the air openings clean and clear to make
sure that the product always has sufficiently cool
temperature.
To clean the chain of the drive system
1. Remove dirt on the outer surface of the chain with a
hard brush or wire brush.
2. Clean the chain with cleaning agent.
3. Remove dirt from internal parts of the chain.
To remove and install the control cages
1. Remove the feed spouts.
2. Remove the cage clamp plates.
2118 - 001 - 27.06.2023
Each 3 h Daily
3. Remove the control cage clamps and the control
cages.
4. Install the control cages in opposite sequence.
To remove and install the blast wheel
blades
1. Remove the feed spouts and the control cages.
Refer to
page 21 .
2. Remove the nuts and remove the blast wheel
covers.
12 h after Each 3
service months
X
X
To remove and install the control cages on
Yearly
O
21