Husqvarna 2-48DS Bedienungsanweisung Seite 11

1. Set the ON/OFF switch to ON.
2. Push the control levers (A) to close the valves for the
abrasive material. Push the OFF button (B) to stop
the blast motors.
3. Set the drive speed to the lowest possible,
approximately 0.5.
2118 - 001 - 27.06.2023
4. Open the drive chain cover.
5. Install the quick-release pin. Push and hold the
A
B
6. Use your other hand to operate the drive system
quick-release pin with a finger.
lever.
The quick-release pin locks into position when the
drive system is engaged.
11