Husqvarna 2-48DS Bedienungsanweisung Seite 16

To select the correct speed
It is important to do the operation with correct drive
speed for best result. If the surface has different quality,
adjust the drive speed for an equal result. Examine the
result and adjust the speed if it is necessary.
• Turn the speed control dial clockwise to increase the
speed.
• Turn the speed control dial counterclockwise to
decrease the speed.
a) Use drive speed 6–10 on concrete surfaces for
light treatment.
b) Use drive speed 0–5 on concrete surfaces for
heavy treatment.
c) Use drive speed 0–2 on steel surfaces.
To start the product
1. Connect the product to a power supply. Refer to
connect the product to a power source on page 15 .
2. Start the dust collector. Refer to the operator's
manual of the dust collector.
3. Attach the dust collector hoses to the product. Refer
To connect a dust collector on page 15 .
to
4. Turn the emergency stop button clockwise to make
sure that the emergency stop button is disengaged.
5. Set the ON/OFF switch to ON.
16
6. Push the ON button (A) to energize the control
panel.
A
7. Engage the drive system. Refer to
drive system on page 10 .
8. Push the ON button (B) to start the blast motors.
9. Wait until the ammeters are in idle position.
10. Turn the speed control dial to set the drive speed.
To
To operate the product
WARNING:
rearward operation only. Do not move the
product forward during operation.
WARNING:
during operation. Abrasive material comes
out of the product at high speed and can
cause injury.
1. Make sure that the work area is safe. Refer to
area safety on page 7 .
2. Fill the separator with abrasive material. Fill the
separator with abrasive material when necessary.
To fill the product with abrasive material on
Refer to
page 14 .
3. Start the product. Refer to
page 16 .
B
To engage the
This product is for
Do not tilt the product
Work
To start the product on
2118 - 001 - 27.06.2023