Husqvarna 2-48DS Bedienungsanweisung Seite 15

3. Unlock and open the separator tray and remove
all contaminations. Do this when you fill abrasive
material or when it is necessary.
4. Fill the separator with abrasive material up to the
separator tray. Fill abrasive material when it is
necessary.
To connect a dust collector
The product has 2 dust collector connections. Speak to
your Husqvarna dealer for information about applicable
dust collectors.
WARNING:
without 2 dust collector hoses attached.
WARNING:
collector if a dust collector hose is damaged.
The risk increases that you breathe in
dust that is dangerous to your health. Use
approved respiratory protection.
1. Examine the dust collector hoses for damages.
2. Make sure that the filters in the dust collector are
clean and not damaged.
2118 - 001 - 27.06.2023
Do not operate the product
Do not use the dust
3. Attach the dust collector hoses safely to the
connections for dust collector. Use parts with
supplied tool and industrial tape.
To connect the product to a power
source
1. Connect the power plug of the product to a grounded
mains outlet or other power source.
2. Make sure that the mains voltage agrees with the
type plate on the product.
Warning lamp of the blast motor
protection and fault power supply
The warning lamp of the blast motor protection comes
on when there is a fault in the power supply. The blast
motors cannot start when the lamp is on. Disengage the
blast motor protection to start the blast motors. Refer to
To disengage the blast motor protection on page 15 .
To disengage the blast motor
protection
1. Change the phases position.
2. Do a check of the warning lamp of the blast motor
protection. If the light is still on, the power supply is
not correct.
3. Do a check of the motor protection switches in the
electrical enclosure.
4. Do a check of the warning lamp of the blast motor
protection. If the light is still on, the power supply is
not correct.
5. Do a check of all phases with a multimeter. Connect
the missing phases.
6. Start the blast motors. Refer to
on page 16 .
7. Do a check of the warning lamp of the blast motor
protection. If the light is still on, speak to your
Husqvarna service agent.
To start the product
15