Renishaw SP25-1 Bedienungsanleitung Seite 39

SP25M user's guide
www.renishaw.com
Step 9 - slowly move body downward in Z axis - STOP immediately when the probe head LED is lit
10. Offset the CMM using a DCC movement of 0.75 mm in a –Z direction at a speed of 5 mm/s.
11. Create a datum coordinate system for the module docking position of the port at the following position: [dat_MOD_port(n)].
12. Slowly move the connected probe head, body and module assembly in a –Y direction clear of the port.
13. Remove the module and place back in the port.
14. Enable the probe signal through software (probe signal now armed).
15. Repeat steps 2 to 13 above for all other modules required.
Issued 06 2022
39