Renishaw SP25-1 Bedienungsanleitung Seite 42

SP25M user's guide
www.renishaw.com
Establishing a docking position for TP20
modules
This section describes how to establish the docking position for the combination of a TM25-20, a TP20 module and a stylus.
1. Latch the port lids open using the triangular plastic inserts provided
2. The desired port should be fitted with a PA25-20 port adapter insert. Orientate the PA25-20 as shown in the image below. Slide the port
adapter into the port ensuring that the side lugs of the adapter locate in the slots at either side of the port. Push the PA25-20 port adapter in
to the port and use a 2.5 mm hex key to tighten. Check that the adapter is fitted correctly and that there is no misalignment.
Steps 1 and 2 - latching port lids open and placing PA25-20 into desired port(n)
3. Ensure the probe head is orientated at an A0 B0 position.
4. Inhibit the probe signal through software.
5. Mount the desired combination of TM25-20, TP20 module and stylus to the probe body.
6. Enable the probe signal through software (probe signal now armed).
7. Qualify (calibrate) the stylus tip on the reference sphere.
Issued 06 2022
42