Renishaw SP25-1 Bedienungsanleitung Seite 19

SP25M user's guide
www.renishaw.com
Mounting
Crash protection
±X, ±Y, ‐Z
+Z
Signal outputs
Signal outputs
Power supply
Probe calibration
Change rack options
FCR25
FCR25-L3
FCR25-L6
FCR25 TC
FCR25 TC-L3
Interface options
UCC S3
UCC2-2 systems
OEM controller systems
Issued 06 2022
Multiwired autojoint - compatible with PH10M PLUS / PH10MQ
PLUS and PH6M probe heads, extension bars and ACR1 / ACR3
sensor changers
Via break out of module or stylus holder
Via integral bump-stop design
Non-linear and non-orthogonal analogue outputs - rate gain and
resolution are not fixed
Non-linear and non-orthogonal analogue outputs - rate gain and
resolution are not fixed
+12 V ﴾±5%﴿, ‐12 V ﴾+10% / +8%﴿, +5% ﴾+10% / ‐13%﴿ dc at probe
Requires that non-linear, third order polynomial calibration method
is used
Three port unit which mounts on MRS
Three port standalone rack version
Six port standalone rack version
Three port unit which mounts on MRS and warms scanning module
Three port standalone rack version
AC3 interface card
Interface for TP20 also required if applicable
19