Renishaw SP25-1 Bedienungsanleitung Seite 33

SP25M user's guide
www.renishaw.com
SP25M operation
Modes of operation
The SP25M is an analogue output measurement probe and may be used in a variety of ways. Principally, these will be either as a single point
measurement probe or as a profile measurement / digitising probe.
Scanning mode
SP25M can be used as a continuous deflection analogue contact scanning probe for profile measurement or for surface digitising purposes. In
this case the CMM controller must respond to the deflections of the probe in real time to maintain surface contact.
Touch-trigger mode
SP25M can be used as a traditional touch-trigger probe using all seven modules in the TP20 probe range. Operating characteristics and
instructions are given in the TP20 system installation and user's guide (Renishaw part number: H-1000-5008) which can be downloaded in
PDF format from the Renishaw website www.renishaw.com/cmmguides.
Reorientation
The SP25M probe may be used in different orientations when mounted on a Renishaw PH10M PLUS or PH10MQ PLUS motorised head. The
design has been optimised to ensure the working range of the probe can be achieved in all orientations.
Issued 06 2022
33