Holders, Fastenings Etc - Dimplex La 60P-Tur Wartungsanleitung

English
Check that the evaporator's refrigerant distributor (Venturi
manifold) has been securely fitted. The individual injection cap-
illaries must not exhibit any damage such as chafe marks. There
must be no damage to the abrasion guard (insulation material).
Fig. 3.6:Abrasion guard for injection capillaries

3.4 Holders, fastenings etc.

Perform a visual inspection. Check the pipe holders. The hold-
ers are located at the following locations in the device:
Pipe bracket
Fig. 3.7:Pipe holder positions
The pipe feed-throughs running through the partition wall must
be in perfect condition, and there must be no damage to the
rubber grommets. Check for chafe marks on the pipes.
Fig. 3.8:Pipe feed-through
EN-10
The retaining pins, fastening nuts, fastening screws and rubber
clamps must be in perfect condition.
Fig. 3.9:Pipe fastenings.
Once the visual inspection is complete, close the upper cover-
ing panels:
Fig. 3.10:Closing the upper covering panels
452167.66.43-EN · FD 0008
Maintenance instructions LA 60P-TUR
2.
2.
1.
www.glendimplex.de
1.
3.
3.