Technical Data - Truma Trumatic E 2400 E Gebrauchsanweisung

Accessories
1. Control unit VG 2
for heaters of driver's cabs in tank vehicles, for the trans-
portation of hazardous goods according to ADR (not to be
used in combination with a time switch).
2. Outside switch AS
for switching the heater on and off from the outside of the
vehicle, e.g. for cargo space heaters (available with 4 m or
10 m connecting cables).
3. Acoustic signalling device ASM
gives an acoustic signal in event of a failure.
4. Time switch ZUE / ZUE 2
for pre-programming 3 switch-on times within 7 days, in-
cluding 4 m connecting cable (suitable for 12 V and 24 V
vehicle electrical system).
ZUE, part no. 39890-00, for installation in existing cut-outs,
suitable for control panel with slide switch.
ZUE 2 part no. 39891-00 with cover frame, suitable for
control panel with rotary switch.
5. Remote sensor FF
monitors the room tem perature independent of the position
of the control panel (available with 4 m or 10 m connecting
cable).
6. Multiple connector MSD
for connecting several accessories (e.g. time switch and
remote sensor).
Extension cable for accessories
items 1 – 6 of 4 m or 10 m (not illustrated).
7. Direct switch DIS 1
for operating the heater at high setting only, without tem-
perature control (available with 10 m connecting cable).
Replaces control panel.
Or direct fixed temperature switch DFS
for operating the heater at a fixed temperature
(40 °C – 70 °C depending on the version). Replaces the
control panel.
All electrical accessories are fitted with a connector and can
be connected individually.

Technical data

determined in accordance with EN 624 or Truma test conditions
Type of gas
Natural gas (from the vehicles own CNG system)
Operating pressure
50 mbar (see type plate)
Rated thermal output
High setting: 2400 W
Low setting: 1200 W
Gas consumption
High setting: 240 l/h
Low setting: 130 l/h
Air flow rate
High setting: approx. 78 m
Low setting: approx. 49 m ³
Current input at 12 V
High setting: 1.1 A
Low setting: 0.6 A
Current input at 24 V
High setting: 0.7 A
Low setting: 0.4 A
Standby
0.01 A
Weight
Heater unit:
Heater unit with peripheral devices: 5.1 kg
Declaration of conformity
The device satisfies the requirements of the following
EC Directives:
– Gas Equipment Directive 90/396/EEC
– Heating Equipment Directive 2001/56/EC, 2004/78/EC,
2006/119/EC
Type approval number e1 00 0144
– EMC Directive 2004/108/EC
– Noise Suppression in Vehicles 2004/104/EC, 2005/83/EC,
2006/28/EC
Type approval number e1 03 2605
– End-of-Life Vehicle Directive 2000/53/EC
The following CE Product Ident. No. is available for
EU countries: CE-0085APO008
The right to effect technical modifications is reserved!
Dimensions
370
All dimensions in mm.
³ /h
/h
4.8 kg
24 123
15