Built-In Needle Threader - ELNA eXcellence 720 Gebrauchsanleitung

q
w
e
e
r

Built-in Needle Threader

Press the "Up/Down Needle" key q until the
needle is in an up position. Turn OFF the power
switch. Lower the presser foot.
Lower the needle threader lever w as far as it will
go. Hook e is automatically inserted into the
needle eye.
Draw the thread from the guide r to the guide t.
The thread is caught under the hook e.
t
Slowly release the lever while holding the thread
end and let the needle threader return to its
original position. A loop of thread y is pulled
y
through the needle eye.
Pull the thread loop off the guide to the back and
manually bring the thread through the needle eye.
• The needle threader can be used with #11 to #16
size needles. Thread weight may vary from 30 to
90.
NOTE: Needle threader cannot be used with a
twin needle or wing needle.
If the needle threader does not catch a thread
loop, check the needle and positioning.
56